![]() Straight-grip stock with Schnabel forend and commemorative brass medallion inlaid in the stock. Open rear sight, brass front blade sight. Same as Model 18, but with an octagon barrel. Same as Model 17, but with an octagon barrel. Same as Model 17, but featured a smoothbore barrel. Same as Model 17, but sights consist of a Lyman combination rear sight, leaf middle sight, and Lyman front sight. Same as Model 17, but sights consist of a Vernier peep sight, leaf middle sight, and Beach combination front sight. Open rear sight, Rocky Mountain front sight. Later model of the Crack Shot that uses the under lever that would be ubiquitous on all subsequent Stevens Boys Rifles. Forearm is small and tapered.Įarly model that actuates the falling-block by means of a side-lever instead of an under lever. Models Ī wide number of different models and variations of Boys Rifles were produced over their production lifespan.ġ8 in (457.2 mm) or 20 in (508.0 mm) barrel The rifles were equipped with an oval-shape walnut or walnut-varnished stock and steel butt plate. The Stevens Boys Rifles were all similar in that they were single-shot rimfire rifles with falling-block actions and could be easily taken down into two-halves with the removal of a knurled thumb screw on the bottom of the receiver. Patent drawing of the takedown mechanism used on Stevens Arms Boys Rifles. In 1909, a patent from Stevens Arms sought to remedy this with the inclusion of an ejector proper which would quickly and sharply snap rearwards to throw an empty cartridge out of the chamber. Instead, the user was required to remove the casing from the chamber with their fingers. This meant that a casing would be partially removed from the chamber upon actuation of the lever, but would not be ejected out of the chamber and away from the rifle. 14 Little Scout was produced from 1906 to 1910, during which time one shortcoming of the Boys Rifle design was addressed: the rifles were only initially equipped with an extractor, but no ejector. ![]() In 1902, Stevens Arms filed a patent for the takedown mechanism that would be used on the Boys Rifles. The Crack Shot would remain unchanged until produced ceased in 1939, with the exception of a brief production run of a modified Crack Shot in 1943. 26) was produced, featuring both a redesigned action and the familiar under-lever (patented together as Patent No. ![]() At this point, a new version of the Crack Shot (designated the No. At its introduction, the breechblock was actuated with a lever found on the side of the rifle, a system that would remain on the Crack Shot until 1912. This rifle would undergo at least two revisions during its production lifespan. ![]() In 1890, Stevens Arms released its first "Boys Rifle" (a term referring to an inexpensive rifle marketed towards children) known as the Crack Shot. 1,059,477 illustrating the lever mechanism used on Stevens Boys Rifles after 1912. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |